[SOLVED] P24D1 Code: Incomplete Regeneration Of Particulate Matter Sensor (2024)

The P24D1 fault code in automobiles indicates a problem with the Exhaust Particulate Matter Sensor.

The most common symptom is the illumination of the Engine Light or Service Engine Soon Warning Light.

The cause of this fault code could be a faulty sensor, an open or shorted harness, or a poor electrical connection. It is important to address this issue promptly as it can lead to increased emissions and reduced fuel efficiency.

The repair process involves visually inspecting the wiring harness and connectors for any damage or corrosion.

The difficulty level of this repair is moderate, and it takes approximately 1.0 hour to fix.

It is crucial to interpret the fault code correctly to ensure the proper repair is performed.

P24D1: Uncovering The Symptoms Of This Auto Fault Code

If you notice the engine light on or service engine soon warning light, it could be a sign of p24d1 fault code. Here are the symptoms to look out for:

• The P24D1 fault code in an automobile can cause several symptoms.
• The most common symptom is the illumination of the engine light or service engine soon warning light.
• Other symptoms include reduced engine power, decreased fuel efficiency, rough idling, and difficulty starting the engine.
• Additionally, the vehicle may emit excessive smoke or have a strong odor of fuel.
• It is important to address these symptoms promptly to prevent further damage to the vehicle and ensure safe driving conditions.

P24D1: What Triggers It?

The P24D1 fault code can be caused by a faulty sensor, open or shorted harness, or poor electrical connection.

• The automobile fault code P24D1 can be caused by a faulty exhaust particulate matter sensor.
• It can also be caused by an open or shorted exhaust particulate matter sensor harness.
• Additionally, a poor electrical connection in the exhaust particulate matter sensor circuit can also trigger this fault code.

Fix Code P24D1: Simple Steps To Get Your Car Running

Below are some possible fixes for the automobile fault code p24d1, including inspecting wiring harness and connectors for damage or corrosion.

• To fix the automobile fault code p24d1, first, check the possible causes listed above.
• Then, visually inspect the related wiring harness and connectors.
• Look for any damaged components and check for broken, bent, pushed out, or corroded connector’s pins.
• This fix will take an estimated repair time of 1.0 hour.

P24D1: Affordable Fix For Your Car

The fault code is P24D1. The estimated repair time is 1.0 hour. The cost of fixing the fault code depends on the repair time.

Most auto repair shops charge between $75 and $150 per hour. These factors are influential in determining the cost of fixing the fault code.

P24D1: Your Car’s Diesel Particulate Filter Needs Attention

The P24D1 fault code is related to the Particulate Matter (PM) sensor in diesel engines.The PM sensor monitors the amount of soot in the diesel exhaust gas.The sensor uses a ceramic element with comb-shaped Interdigital Electrodes (IDE), a heater, and a positive temperature coefficient resistor for temperature measurement.

The sensor performs a regeneration process to clean off the soot before the measurement phase begins.The P24D1 code is set when the PM sensor control unit detects an internal fault of the sensor, fault of the sensor circuitry, or low voltage on the sensor supply circuit.

This fault code indicates that the regeneration process was incomplete, which can affect the collection efficiency of the Diesel Particulate Filter (DPF).

FAQ

Wrap Up

If your engine light is on, it could be due to a faulty exhaust particulate matter sensor, an open or shorted harness, or poor electrical connection. Visually inspect the wiring harness and connectors for damage or corrosion. Check for broken, bent, or pushed out pins.

Resources

• Resource 1
• Resource 2
• Resource 3
• Resource 4